物料中的塊料由于通過不了卸料器的卸料口,因此會造成物料阻塞并引起流量調節(jié)閥產生非真實流量的信號,輕者影響工藝系統(tǒng)的正常生產，重者則會造成原料和燃料之間的比例嚴重失調,從而造成燃燒設備中的溫度過高,導致設備事故。The block materials in the material cannot pass through the discharge port of the unloader, which can cause material blockage and cause the flow control valve to produce non real flow signals. Mild cases can affect the normal production of the process system, while severe cases can cause a serious imbalance between the ratio of raw materials and fuel, resulting in high temperatures in the combustion equipment and equipment accidents.       塊料破碎閥可水平或者垂直安裝在卸料出口處卸料設備的入料端,如流量調節(jié)閥或氣動切斷閥的前部。當有些物料中出現(xiàn)較大塊狀物時,可即刻將它破碎,以防止這些大塊物料堵塞卸料閥門的通道,保證通暢卸料。【電話/微信咨詢：陳經理18068546632】破碎閥的轉子上安裝有放射狀布置的破碎爪，撥動塊料物料通過柵格并將其破碎。塊料破碎閥的運轉安全性是通過在電控箱中集成的電機轉速檢測裝置來保證,當物料中的某些塊料物料無法破碎而卡住轉子時,轉速檢測裝置將報警并自動反轉，將無法破碎塊料物料推開后再進行正轉。當正轉或反轉都被卡住時,破碎閥則自動停機，等待排除故障后再運行。轉速檢測裝置為選配裝置,有此要求時需要在設備訂貨時說明。常見破碎物料：沫煤、鋰礦、結塊顆粒、磷酸鐵粉、電石渣燒生石灰、碳酸鈣、鋰電池正極材料碳納米管材料、硬脂酸鹽產品、凈化灰塊狀物料、炭黑結塊。水泥破碎閥  塊料破碎閥  電動塊料破碎器   電動破碎閥  粉煤灰破碎閥   電石渣破碎閥   斜槽水泥塊料破碎閥  水泥結塊打散卸料閥【電話/微信咨詢：陳經理18068546632】電動破碎閥  水泥塊料破碎機  可拆卸破碎閥、物料破碎閥、粉煤灰破碎打散閥、電石渣破碎打散閥            《掃二維碼-添加 陳經理 微信-咨詢破碎卸料閥》The block crushing valve can be installed horizontally or vertically at the feeding end of the discharge equipment at the discharge outlet, such as the front of the flow regulating valve or pneumatic cut-off valve. When large chunks appear in some materials, they can be immediately crushed to prevent these chunks from blocking the discharge valve channel and ensure smooth discharge.The rotor of the crushing valve is equipped with radially arranged crushing claws, which move the block material through the grid and crush it.The operational safety of the block crushing valve is ensured by the motor speed detection device integrated in the electric control box. When some block materials in the material cannot be crushed and get stuck in the rotor, the speed detection device will alarm and automatically reverse, pushing away the block materials that cannot be crushed before proceeding with forward rotation. When both forward and reverse rotation are stuck, the crushing valve will automatically stop and wait for the fault to be resolved before running again. The speed detection device is an optional device, and this requirement needs to be explained when ordering the equipment.